|
|
|
|
|
|
The
TesTex, Inc. PS-2000 Multichannel NDT inspection system, can quickly
and accurately inspect ferrous and non-ferrous metal tubing from the
pipe O.D.
|
|
The
PS-2000 is based on the Low Frequency Electromagnetic Technique
(LFET) and normally has 8-channels for detection of MIC
(microbiological induced corrosion) Attack, FAC (Flow Accelerated
Corrosion), cracking, erosion, corrosion, and pitting wall losses.
A PS2000 waveform indicating caustic gouging
Caustic
gouging inside of service piping
|
|
Typical
applications for the PS-2000 are Service Water Piping, Fire
Protection, Coal Mill Piping, and virtually any piping with access to
the pipe O.D. In addition to piping, the PS-2000 can be used to
quickly inspect pressure vessels and heat exchanger shells. The LFET
PS2000 System can inspect through coatings.
|
|
The
PS-2000 does not require couplant or permanent magnets, which allows
for quicker inspections with minimal pipe preparation.
|
|
|
- Inspects straight sections and bends
- Minimal pipe preparation
- Wide frequency range 5Hz to 30KHz
- Real-Time Display
- Low signal to noise ratio
- Inspects through coatings
- Scanner sizes .625”(16.1mm) and greater
- Cable lengths of up to 50’ (15m)
- Inspects through I.D. or O.D. scale
- Can be used with TesTex L.F.E.T Crawler
- Small modular PC based design
- Windows based software
- 110/220v Operation
|
|
|
|
|
